OPI-3601
Specifications Manual
14
7.8. Auto Trigger
A dedicated stand contains a magnet and when the OPI-3601 is placed into this stand, it can
detect this magnet and enters auto trigger mode. The scanner starts scanning automatically when
it detects a change in brightness that occurs when a bar code label is presented in front of it.
7.8.1. Stand Detection
“Stand detection - Auto trigger Flow”
Figure 8: Stand Detection Flow
* The dedicated stand needs to be purchased separately if auto trigger is used.
* Auto trigger is disabled by default and needs to be enabled if it is used.
To Next Page
Loading...
