-106 CSvision -
4.5. Sensor Setup CSvision – Display
In this tab you can make settings for the backlight LED (=visual alarms).
4.5.1. Visual Alarms
Independent of the selected signal for the analog output, a signal from the following list can be selected under
General/ Main display source, which is shown in the digital display of the electronics:
Temperature value 1-color-mode
Temperature value 2-color-mode
Temperature of the detector
Temperature of the electronics
For the visual alarm areas up to eight alarm limits can be assigned to a signal. The selected signal can be
selected under Source independent of the value shown in the display and independent of the analog output.
To Next Page
Loading...
Need help?
General
