Note
Before you open the COM port please close the CompactPlus Connect software as this application may access
the same sensor/ COM port.
Please make sure that the sensor is set to bidirectional digital communication.
Now you can enter a binary command as hexadecimal value out of the according command list of the
connected sensor. After pressing Send the answer will be shown in the line Receive (also as HEX value).
Below the receive line you will find the Integer decimal value of the answer as well as the calculated
Temperature or the Decimal value which is calculated by dividing the answer by 1000. This calculation is
used for the emissivity value e.g.
Example 1: CTratio/ Polling of the process temperature
To Next Page
Loading...
