Install Oracle Solaris 11 Over a Network (Oracle SPARC)
7.
Install the adapter software on the client server.
The software installed in Step 5 is required to boot the client server over the adapter interface.
You now must install the software in order for the OS to use the client's interfaces in normal
operation.
Before installing the SUNWi40e driver, ensure that the client server does not already have the
driver installed.
# pkginfo | grep SUNWi40e*
■ If the software is installed, this command will return the package name you
typed in. In that case, skip to Step 8.
■ If needed, install the software from the download center at My Oracle
Support (https://support.oracle.com).
8.
Display the configuration information for all datalinks or the specified datalink.
By default, the server is configured to have one datalink for each known network device.
# dladm show-phys
The output should include lines similar to this:
LINK MEDIA STATE SPEED DUPLEX DEVICE
net10 Ethernet up 10000 full i40e6
net11 Ethernet up 10000 full i40e7
net14 Ethernet up 10000 full i40e5
net15 Ethernet up 10000 full i40e4
Related Information
■
“Configure the Network Interface (Oracle Solaris)” on page 48
■
“Boot Options” on page 48
■
“Boot Over the Network (PXE)” on page 49
■
“Boot Over a 10GbE Network (Oracle Solaris x86/x64 and Linux)” on page 49
54 Oracle Quad Port 10GBase-T Adapter User's Guide • June 2019
To Next Page
Loading...
General