Installation and Configuration
Oracle Secure Backup and ACSLS D-5
Unsupported Oracle Secure Backup Commands
The following Oracle Secure Backup commands are not supported for ACSLS tape
libraries:
■ importvol
■ extractvol
■ insertvol
■ clean
■ opendoor
■ closedoor
Installation and Configuration
The Oracle Secure Backup media server attached to the ACSLS server must be a Linux
32-bit media server.
Oracle Secure Backup installation assumes that the ACSLS hardware and software has
been correctly installed and configured. Oracle Secure Backup installation procedures
do not attempt to create or modify any ACSLS configuration files.
Oracle Secure Backup handles ACS tape devices no differently from other devices. The
Oracle Secure Backup device driver (if any) is installed, and special device files are
created. The data path is controlled solely by Oracle Secure Backup. ACSLS is not
involved.
creating Oracle Secure Backup objects for ACSLS devices is performed with the mkdev
command in obtool with the following modifications:
■ For ACSLS tape libraries, the usual host:devname attach point is replaced with
information identifying the acs of the tape library and the host name and port
where the associated ACS software is listening. A barcode reader is assumed, and
barcodes are required.
■ For each tape drive contained within an ACSLS tape library, you must specify
acs, lsm, panel, and drive. The acs is obtained from the tape library in which
the tape drive is contained.
See Also: Oracle Secure Backup Reference for mkdev syntax and
semantics
To Next Page
Loading...
Need help?
General