EN
10
information on pairing, refer to their User Guides.
• When the foot pod is paired successfully, the watch will
display
• When the bike pod is paired successfully, the watch will
display
NOTE If pairing is weak and unstable:
• Shorten the distance between the device and watch.
• Re-adjust the position of the device.
• Check the batteries. Replace them when necessary.
NOTE If the watch is already paired with SZ909 chest belt,
and you want to pair with another chest belt, you have to
first delete the SZ909 chest belt before you are able to pair
with another chest belt. This principle also applies to bike
pod and foot pod.
INPUT BIKE WHEEL SIZE (FOR BIKE POD)
The watch will not show “WHEEL SIZE” if no bike pod is
paired. For details of bike wheel size, refer to “BIKE WHEEL
SIZE” section in this manual.
If your watch is paired with bike pod, you will be asked to
input the wheel size values.
1. Press MODE repeatedly to select
.
2. Press SET.
3. Press ST/LAP/+ repeatedly to select “WHEEL SIZE”.
4. Press SET.
5. Input the bike wheel size by pressing ST/LAP/+ to
increase values or -/SP to decrease values.
6. Press SET to confirm.
REMOVE PAIRED DEVICE
The watch will not show “DEVICE REMOVE” if no device
is paired.
1. Press MODE repeatedly to select
.
2. Press SET.
3. Press ST/LAP/+ repeatedly to select “DEVICE
To Next Page
Loading...
