EN
25
To synchronise watch with software:
On the PC
1. Plug in the USB dongle.
2. Start up the software by double-clicking
.
3. Click
on the software.
On the watch
4. Press MODE repeatedly to select
.
5. The screen
will be displayed. Press SET
to start synchronising.
On the PC
6. The message box below will be displayed.
UPLOAD
DOWNLOAD
• To upload data from the software to the SE833 watch,
click
.
• To download data from the SE833 watch to the software,
click
.
• To exit, press Esc.
NOTE Synchronisation cannot be cancelled while in
progress.
On the watch
7. If synchronisation is successful, the screen will display
. If synchronisation fails, the screen will
display
. Press ST/LAP/+ then SET to
try again or press MODE to exit.
NOTE For more details of the software interface and
functions, refer to the PC Application Software User
Guide inside the CD-ROM.
To Next Page
Loading...
