4 - 51
CRANKSHAFT
NOTE:
NOTE:
CAUTION:
DISASSEMBLING THE CRANKCASE
1. Remove:
crankcase bolts
Loosen each bolt 1/4 of a turn at a time, in
stages and in a crisscross pattern. After all of
the bolts are fully loosened, remove them.
Loosen the bolts in decreasing numerical or-
der (refer to the numbers in the illustration).
The numbers embossed on the crankcase in-
dicate the crankcase tightening sequence.
2. Remove:
right crankcase
Set the left crankcase half under then put in the
flat head screw driver to the separating slit .
First check that the shift drum segment’s
teeth and the drive axle circlip are properly
positioned, then remove the right crank-
case.
Do not damage the crankcase mating sur-
faces.
1
5
~
To Next Page
Loading...