Orion AGB-21G - Installing the Starter Clutch

4 - 44
MAGNETO AND STARTER GEAR
30 Nm (3.0 m kg)
b. When turning the starter clutch gear clock-
wise
a
, the starter clutch and the starter
clutch gear should engage.
If the starter clutch gear and starter clutch do
not engage, the starter clutch is faulty and
must be replaced.
c. When turning the starter clutch gear counter-
clockwise
b
, it should turn freely.
If the starter clutch gear does not turn freely,
the starter clutch is faulty and must be re-
placed.
3. Inspect:
dowel pins
1
compression springs
2
spring caps
3
Wear/Damage Replace.
4. Inspect:
starter wheel gear
(contacting surface)
Pitting/Wear/Damage
Replace.
INSTALLING THE STARTER CLUTCH
1. Install:
starter clutch assembly
1
2. Unloosen the starter clutch assembly by us-
ing the center punch.
3. Install:
compression springs
1
spring caps
2
dowel pins
3
2. Check:
starter clutch operation
a. Hold the starter clutch.