4 - 25
CAMSHAFT /VALVES AND VALVE SPRINGS
NOTE:
NOTE:
CAUTION:
INSTALLING THE VALVES
The following procedure applies to all of the
valves and related components.
1. Deburr:
valve stem end
(with an oil stone)
2. Lubricate:
valve stem
oil seal
(with the recommended lubricant)
Recommended lubricant
Molybdenum disulfide oil
3. Install:
valve
1
oil seal
2
valve springs
3
upper spring seat
4
(into the cylinder head)
Install the valve springs with the larger pitch a
facing up.
4. Install:
valve cotters
1
Install the valve cotters by compressing the
valve springs with the valve spring compressor
2
and attachment
3
.
5. To secure the valve cotters onto the valve
stem, lightly tap the valve tip with a soft-face
hammer.
Hitting the valve tip with excessive force
could damage the valve.
To Next Page
Loading...