5 - 12
FRONT WHEEL AND REAR WHEEL
ı
REMOVAL POINTS
Brake fluid
1. Remove:
[Front]
Brake master cylinder cap ①
[Rear]
Brake master cylinder cap ①
NOTE:
Do not remove the diaphragm.
2. Connect the transparent hose ② to the
bleed screw ① and place a suitable con-
tainer under its end.
3. Loosen the bleed screw and drain the
brake fluid while pulling the lever in or
pushing down on the pedal.
ACHTUNG:
CAUTION:
Do not reuse the drained brake fluid.
Brake fluid may erode painted surfaces or
plastic parts. Always clean up spilled
fluid immediately.
NOTE:
Do not remove the diaphragm.
To Next Page
Loading...