5 - 4
Wheel axle
1. Measure:
Wheel axle bends
Out of specification
→
Replace.
Use the dial gauge ①
!
.
NOTE:
The bending value is shown by one half of the
dial gauge reading.
WARNING
Do not attempt to straighten a bent axle.
Wheel axle bending limit:
0.5 mm
Brake disc
1. Measure:
Brake disc deflection (only rear brake
disc)
Use the dial gauge ① .
Out of specification
→
Inspect wheel
runout.
If wheel runout is in good condition,
replace the brake disc.
2. Measure:
Brake disc thickness
!
b
Out of limit
→
Replace.
Brake disc deflection limit:
Rear:
<Limit>: 0.15 mm
Brake disc thickness:
Front:
3.0 mm
<Limit>: 2.5 mm
Rear:
3.0 mm
<Limit>: 2.5 mm
FRONT WHEEL AND REAR WHEEL
To Next Page
Loading...