Orion AGB-21G - Installing the Swingarm; Installing the Drive Chain

5--41
REAR SHOCK ABSORBER AND SWINGARM
50 Nm (5.0 m kg)
CAUTION:
INSTALLING THE SWINGARM
1. Lubricate:
bearings
spacers
pivot shaft
Recommended lubricant
Molybdenum disulfide grease
2. Install:
Swingarm
3. Install
rear shock absorber assembly
rear wheel
Refer to “INSTALLING THE REAR SHOCK
ABSORBER ASSEMBLY” and ”REAR
WHEEL”.
4. Adjust:
drive chain slack
Refer to “ADJUSTING THE DRIVE CHAIN
SLACK” in chapter 3.
Drive chain slack
30
50 mm
INSTALLING THE DRIVE CHAIN
1. Lubricate:
drive chain
master link (New)
Recommended lubricant
Engine oil or chain lubricant
suitable for non-O-ring chains
2. Install:
master link
1
master link plate
2
3. Install:
master link clip
1
The closed end of the master link clip must
face in the direction of drive chain rotation.
Never install a new drive chain onto worn
drive chain sprockets; this will dramatical-
ly shorten the drive chain’s life.
4. Adjust:
drive chain slack
Refer to “ADJUSTING THE DRIVE CHAIN
SLACK” in chapter 3.
Drive chain slack
30
50 mm