Orion AGB-21G - Front Brake Pad Inspection and Replacement

3 - 13
FRONT BRAKE PAD INSPECTION AND REPLACEMENT
FRONT BRAKE PAD INSPECTION AND
REPLACEMENT
1. Inspect:
Brake pad thickness A
Out of specification m Replace as a
set.
2. Replace:
Brake pad
Brake pad thickness:
4.0 mm
<Limit>: 1.0 mm
Brake pad replacement steps:
Remove Bolt 1 and 2
Loosen the Caliper
CAUTION:
Do not reuse the drained brake fluid.
Tighten the bleed screw.
T
R
.
.
Bleed screw 3 and 4 :
18 Nm (1.8 m • kg)
Install the Caliper Bolt 1 and 2
T
R
.
.
Bolt (brake caliper):
25 Nm (2.5 m • kg)
Remove Bolt 3 and 4
Replace the Brake pad
3. Inspect:
Brake fluid level
Refer to “BRAKE FLUID LEVEL
INSPECTION” section.
4. Check:
Brake lever operation
A softy or spongy feeling m Bleed
brake system.
Refer to “BRAKE SYSTEM AIR
BLEEDING” section.