5 - 17
FRONT WHEEL AND REAR WHEEL
Brake master cylinder kit
1. Clean:
Brake master cylinder
Brake master cylinder kit
Clean them with brake fluid.
2. Install:
Brake master cylinder cup (primary) ①
Brake master cylinder cup (secondary) ②
To brake master cylinder piston ③
.
NOTE:
Apply the brake fluid on the brake master cyl-
inder cup.
After installing, cylinder cup should be
installed as shown direction. Wrong instal-
lation cause improper brake performance.
.
3. Install:
Spring ①
To brake master cylinder piston ② .
NOTE:
Install the spring at the smaller dia. side.
4. Install:
[Front]
Brake master cylinder kit ①
Circlip ②
Brake master cylinder boot ③
To brake master cylinder ④.
[Rear]
Brake master cylinder kit ①
Push rod ②
Brake master cylinder boot ③
To brake master cylinder ④
NOTE:
Apply the brake fluid on the brake master
cylinder kit.
Apply the lithium soap base grease on the tip
of the push rod.
When installing the circlip, use a long nose
circlip pliers.
WARNING
To Next Page
Loading...