Orion AGB-21G - Rear Shock Absorber and Swingarm

5-36
REAR SHOCK ABSORBER AND SWINGARM
NOTE:
NOTE:
NOTE:
NOTE:
REMOVING THE REAR SHOCK ABSORBER
ASSEMBLY
1. Stand the motorcycle on a level surface.
Securely support the motorcycle so that
there is no danger of it falling over.
Place the motorcycle on a suitable stand so that
the rear wheel is elevated.
2. Remove:
rear shock absorber assembly lower bolt
1
While removing the rear shock absorber as-
sembly lower pin, hold the swingarm so that it
does not drop down.
3. Remove:
rear shock absorber assembly upper bolt
1
rear shock absorber assembly
Raise the swingarm and then remove the rear
shock absorber assembly from between the
swingarm and relay arm.
REMOVING THE DRIVE CHAIN
1. Stand the motorcycle on a level surface.
Securely support the motorcycle so that
there is no danger of it falling over.
Place the motorcycle on a suitable stand so that
the rear wheel is elevated.
2. Remove:
chain cover
3. Remove:
master link clip
(with interlocking slip-joint pliers )
4. Remove:
master link plate
1
master link
2
5. Remove:
drive chain
WARNING
WARNING