Orion AGB-21G - Wheel; Removal Points; Wheel Bearing

5 - 3
FRONT WHEEL AND REAR WHEEL
REMOVAL POINTS
Rear wheel
1. Remove:
Wheel ①
NOTE:
Push the wheel forward and remove the drive
chain ② .
Wheel bearing (if necessary)
1. Remove:
Bearing ①
NOTE:
Remove the bearing using a general bearing
puller ② .
INSPECTION
Wheel
1. Measure:
Wheel runout
Out of limit → Repair/replace.
2. Inspect:
Bearing
Rotate inner race with a finger.
Rough spot/seizure → Replace.
NOTE:
Replace the bearings, oil seal and wheel collar
as a set.
Wheel runout limit:
Radial ① : 2.0 mm
Lateral ② : 2.0 mm