5 - 18
FRONT WHEEL AND REAR WHEEL
.
Front brake master cylinder
1. Install:
Brake master cylinder ①
Brake master cylinder bracket ②
Bolt (brake master cylinder bracket) ③
NOTE:
Install the bracket so that the arrow mark b
face upward.
First tighten the bolts on the upper side of the
brake master cylinder bracket, and then
tighten the bolts on the lower side.
T
R
.
.
9 Nm ( 0.9 m • kg )
2. Install:
Brake lever ①
Bolt (brake lever) ②
NOTE:
Apply the lithium soap base grease on the
brake lever sliding surface, bolt and contacting
surface of the brake master cylinder piston.
Rear brake master cylinder
1. Install:
Copper washer ①
Brake hose ②
Union bolt ③
Always use new copper washers.
ACHTUNG:
CAUTION:
Install the brake hose so that its pipe por-
tion ① directs as shown and lightly
touches the projection ② on the brake
master cylinder.
T
R
.
.
6 Nm ( 0.6 m • kg )
T
R
.
.
25 Nm (2.5 m• kg)
Front brake master cylinder③
WARNING
To Next Page
Loading...