Orion AGB-21G - Checking the Clutch Springs; Checking the Clutch Outer Case; Checking the Clutch Center Sleeve

4 - 36
CLUTCH
NOTE:
NOTE:
2. Measure:
clutch plate warpage
(with a surface plate and thickness gauge
1
)
Out of specification
Replace the clutch
plates as a set.
Clutch plate warpage limit
Less than 0.1
mm
CHECKING THE CLUTCH SPRINGS
The following procedure applies to all of the
clutch springs.
1. Check:
clutch spring
Damage
Replace the clutch springs as a
set.
2. Measure:
clutch spring free length
Out of specification
Replace the clutch
springs as a set.
Clutch spring free length
20.5 mm
<Limit>: 19.5 mm
CHECKING THE CLUTCH OUTER CASE
1. Check:
clutch outer case dogs
Damage/pitting/wear
Deburr the clutch
outer case dogs or replace it.
Pitting on the clutch housing dogs will cause er-
ratic clutch operation.
CHECKING THE CLUTCH CENTER SLEEVE
1. Check:
clutch center sleeve splines
Damage/pitting/wear
Replace the clutch
center sleeve.
Pitting on the clutch sleeve splines will cause er-
ratic clutch operation.