3 - 17
DRIVE CHAIN SLACK ADJUSTMENT
5. Install:
Drive chain
Joint
Master link clip
CAUTION:
Be sure to install the master link clip to the
direction as shown.
Turning direction
6. Lubricate:
Drive chain
Drive chain lubricant:
SAE 10W-30 motor oil or suit-
able chain lubricants
DRIVE CHAIN SLACK ADJUSTMENT
1. Elevate the rear wheel by placing the
suitable stand under the engine.
2. Check:
Drive chain slack A
Above the seal guard installation bolt.
Out of specification m Adjust.
NOTE:
Before checking or adjusting, rotate the
rear wheel through several revolutions and
check the slack several times to find the tight-
est point. Check and/or adjust the drive chain
slack with the rear wheel in this “tight chain”
position.
Drive chain slack:
30 ~ 50 mm
ķ
ĸ
Ĺ
Ａ
Ａ
To Next Page
Loading...