4 - 38
CLUTCH
NOTE:
60 Nm (6.0 m kg)
NOTE:
CHECKING THE CLUTCH PUSH RODS
1. Check:
oil tube
1
oil thimble spring
2
oil thimble
3
Cracks/damage/wear Replace the de-
fective part(-s).
2. Measure:
oil thimble spring ② free length
Out of specification Replace the oil thim-
ble spring.
Oil thimble spring free length
17.5 mm
INSTALLING THE CLUTCH
1. Install:
clutch assy
1
thrust washer④,make sure the “OUT SIDE”
mark on the washer is upturned.
Make sure that the teeth on the lock washer are
correctly aligned with the grooves on the clutch
boss.
2. Tighten:
clutch boss nut
5
While holding the clutch boss with the universal
clutch holder , tighten the clutch boss nut.
3. Bend the lock washer tab ③ along a flat side
of the nut.
To Next Page
Loading...