Orion AGB-21G - Checking the Friction Plates

To Next Page

To Previous Page

4 - 35

CLUTCH

NOTE:

REMOVING THE CLUTCH

2. Straighten the lock washer tab ③

3. Remove:

clutch boss nut ①

While holding the clutch boss with the univer-

sal clutch holder , loosen the clutch boss nut.

CHECKING THE FRICTION PLATES

The following procedure applies to all of the fric-

tion plates.

1. Check:

friction plate

Damage/wear

Replace the friction plates

as a set.

2. Measure:

friction plate thickness

Out of specification

Replace the friction

plates as a set.

Measure the friction plate at four places.

Friction plate thickness

2.85

2.95 mm

<Limit>: 2.7 mm

CHECKING THE CLUTCH PLATES

The following procedure applies to all of the

clutch plates.

1. Check:

clutch plate

Damage

Replace the clutch plates as a

set.

1. Remove:

Screw

4. Remove:

snap spring ①

washer ②