6 - 2
IGNITION SYSTEM
IGNITION SYSTEM
INSPECTION STEPS
Use the following steps for checking the possibility of the malfunctioning engine being attributable to
ignition system failure and for checking the spark plug which will not spark.
*marked: Only when the ignition checker is used.
NOTE:
Remove the following parts before inspection.
1) Seat
2) Fuel tank
Use the following special tools in this inspection.
Spark gap test
*Clean or replace
spark plug.
Check entire ignition
system for connection.
(couplers, leads and
ignition coil)
Repair or replace.
.ecalpeR.hctiws pots enigne kcehC
.ecalpeRlioc yramirP.lioc noitingi kcehC
Rlioc yradnoceS eplace.
.eca
lpeRlioc pukciP.otengam IDC kcehC
.ecalpeRlioc gnigrahC
Replace CDI unit.
No spark
OK
OK
OK
OK
Spark
No good
No good
No good
No good
No good
No good
No good
To Next Page
Loading...