Orion AGB-21G - Checking the Drive Chain

5-39
REAR SHOCK ABSORBER AND SWINGARM
NOTE:
4. Check:
1
spacer
2
Damage/wear Replace.
bearings
Damage/pitting
Replace.
CHECKING THE DRIVE CHAIN
1. Measure:
10-link section
a
of the drive chain
Out of specification
Replace the drive
chain.
10-link drive chain section
limit (maximum)
144.4 mm
While measuring the 10-link section, push
down on the drive chain to increase its tension.
Measure the length between drive chain roller
1
and
11
as shown.
Perform this measurement at two or three dif-
ferent places.
2. Check:
drive chain
Stiffness
Clean and lubricate or replace.
3. Clean:
drive chain
a. Wipe the drive chain with a clean cloth.
b. Put the drive chain in kerosine and remove
any remaining dirt.
c. Remove the drive chain from the kerosine
and completely dry it.