Orion AGB-21G - Front Brake Adjustment; Rear Brake Adjustment

3 - 12
FRONT BRAKE ADJUSTMENT
3. Install:
Diaphragm
Reservoir cap
If bleeding is difficult, it may be necessary to
let the brake fluid system stabilize for a few
hours. Repeat the bleeding procedure when
the tiny bubbles in the system have disap-
peared.
j. Add brake fluid to the level line on the
reservoir.
Check the operation of the brake after
bleeding the brake system.
FRONT BRAKE
1. Check:
Brake lever position A
Brake lever position A :
Standard position Extent of adjustment
100 mm
Unavailable
REAR BRAKE ADJUSTMENT
REAR BRAKE ADJUSTMENT
1. Check:
Brake pedal height A
Out of specification m Adjust.
Brake pedal height A :
10 mm
2. Adjust:
Brake pedal height
Pedal height adjustment steps:
Loosen the locknut ① .
Turn the adjusting nut ② until the pedal
height D is within specified height.
Tighten the locknut.
Adjust the pedal height between the
maximum and the minimum
After the pedal height adjustment, make
sure that the rear brake does not drag.
WARNING
NOTE:
WARNING