5 - 9
FRONT WHEEL AND REAR WHEEL
8. Install:
Left drive chain puller ①
Bolt (wheel axle) ②
Adujust bolt (wheel axle) ③
NOTE:
Temporarily tighten the nut (wheel axle) at this
point.
9. Adjust:
Drive chain slack A
Refer to “DRIVE CHAIN SLACK
ADJUSTMENT” section in the CHAP-
TER 3.
Drive chain slack:
30 ~ 40 mm
10. Tighten:
Reft drive chain puller
Locknut ③
T
R
.
.
65 Nm (6.5 m
kg)
·
T
R
.
.
12 Nm (1.2 m kg)·
7. Install:
Left drive chain puller ①
Wheel axle ②
NOTE:
Install the left drive chain puller, and insert
the wheel axle from left side.
Apply the lithium soap base grease on the
wheel axle.
Nut (wheel axle) ②
To Next Page
Loading...