5 - 28
FRONT FORK AND STEERING
4. Install:
Steering ring nut ①
Tighten the steering ring nut using the
steering nut wrench 3 .
Refer to “STEERING HEAD INSPEC-
TION AND ADJUSTMENT” section in
the CHAPTER 3.
T
R
.
.
30 Nm (3 m · kg)
5. Check the steering stem by turning it lock
to lock. If there is any binding, remove
the steering stem assembly and inspect
the steering bearings.
6. Install:
Lower ①
Upper bracket ②
NOTE:
Temporarily tighten the pinch bolts (lower
bracket).
Do not tighten the pinch bolts (upper bracket)
yet.
7. Install:
Washer
Steering stem nut ③
T
R
.
.
70 Nm (7.0 m · kg)
8. After tightening the nut, check the steer-
ing for smooth movement. If not, adjust
the steering by loosening the steering
ring nut little by little.
Upper bracket ②
Front fork ③
To Next Page
Loading...