3 - 25
STEERING HEAD INSPECTION AND ADJUSTMENT
Tighten the steering ring nut using
steering nut wrench .
NOTE:
Apply the lithium soap base grease on the
thread of the steering stem.
Set the torque wrench to the steering nut
wrench so that they form a right angle.
T
R
.
.
Steering ring nut (initial tightening):
30 Nm ( 3 m • kg )
Loosen the steering ring nut one turn.
Retighten the steering ring nut using the
steering nut wrench.
Avoid over-tightening.
Check the steering stem by turning it lock
to lock. If there is any binding, remove the
steering stem assembly and inspect the
steering bearings.
Install the upper bracket ⑤ , washer, steer-
ing stem nut ⑥ , handlebar ⑦ , handlebar
upper holder ⑧
.
CAUTION:
First tighten the bolts on the front side of
the handlebar holder, and then tighten
the bolts on the rear side.
T
R
.
.
Steering stem nut:
70 Nm ( 7 m • kg )
Handlebar upper holder:
25 Nm ( 2.5 m • kg )
③
ĺ
WARNING
To Next Page
Loading...