Operation
27
DTX-2200-3000 AC/DC
■
PULSE
When using one of the 3 TIG welding processes, it makes it possible to set one of the 4 pulsation modes available
on the welding machine, using the relevant button:
L27 SYN
PULSE
L28 FAST
PULSE
L28 ULTRA FAST
PULSE
L29 SLOW
PULSE
L27 Synergic
pulse
(SYN
PULSE)
W
ARNING:
LED L27 switched on and steady.
This can only be programmed when the TIG DC with HF
ignition
or TIG DC with
“Lift”
type
ignition
welding
processes are used.
L28 Fast
pulsations
(FAST
PULSE)
W
ARNING:
LED L28 switched on and steady.
This can only be programmed when the TIG DC with HF
ignition
or TIG DC with
“Lift”
type
ignition
welding
processes are used.
L28 Ultra fast
pulse
(ULTRA FAST
PULSE)
W
ARNING:
LED L28 switched on and flashing.
This can only be programmed when the TIG DC with HF
ignition
or TIG DC with
“Lift”
type
ignition
welding
processes are used.
L29 Slow
pulse
(SLOW
PULSE)
W
ARNING:
LED L29 switched on and steady.
This can only be programmed when the 3 TIG welding processes are used.
WARNING: The operator can decide to TIG weld without using any
pulse mode.
If this is the case, the 4 LEDs are
switched
off.
To Next Page
Loading...
