Quantization can be toggled ON/OFF by pressing SHIFT + REC inside the Rec Settings Menu.
When quantization is OFF, the original timing of the recording is preserved.
You can later apply quantization by pressing the 2nd encoder. The quantization amount is set by
the (Qnt%) parameter and it reduces the timing offsets of each step until they are 0 (fully quantized).
This is a destructive process that can be undone with undo. It will also remove the manually set
timing offsets.
OTHER TRANSPORT COMMANDS
Play/Pause button behavior can be set in config as:
- “OFF”, or pause disabled
- “ON”, pause enabled. When the OXI One is playing, a tap on Play will Pause all the
sequencers.
- “RESET”, instead of Pausing, tapping the Play button when the OXI One is running will reset
the playback head of all sequencers according to their punch in settings.
Shift + MUTE opens the Nudge menu
Shift + MUTE + Sequencer button resets the playback of the selected sequencer according
to its punch in setting.
MUTE + Any pad of the 1st column mutes the selected sequencer. It means its playback head
continues moving but the sequencer doesn’t emit any MIDI or CV event.
Long press Shift + Play for more than 3 seconds to take a rest from sequencing ;)
TRANSPORT CC COMMANDS
In order to control the Transport of a DAW or any other device when OXI One is not the Master (thus
realtime messages are ignored by the master), you can assign a MIDI CC message to Stop, Play and
Rec.
These MIDI CC messages will be sent from the OXI One through the selected MIDI channel, port A.
- Stop: CC 105
- Play: CC 106
- Rec: CC 107
This feature can be enabled in Config, MIDI section: CC Transport Msgs Channel
Can be “Off” or any channel from 1 to 16 of the Port A.
When this setting is not “Off”, you can tap any of the buttons and the OXI One will emit the
corresponding CC message so you can use MIDI learn in your DAW to quickly assign these three
commands.
To Next Page
Loading...