probability of playing the note in different octaves, but also increases the octave range of the
randomization.
- Rand Probability of notes being triggered, 100% means no randomization.
- Rand Retrigger probability, which introduces ratcheting effect on steps.
In Mono and Multitrack modes it also affects Skip (step parameter) the following way:
- With negative values, add skips to the steps.
- Positive values from 0% to 32%, steps set to Skip start to be triggered, some retriggers
might appear as well.
- 33% to 100%, increase the probability of retriggers appearing. Steps set to Skip have even
more chance of being triggered.
In Multitrack mode instead of Random Octave you have Random Gate, it doesn’t affect the TIEs.
In Matriceal and Multitrack modes Random Perform parameters are independent per track.
Random perform can be enabled/disabled on individual tracks in Multitrack mode. Pressing the
Random Button, the first column will light up orange. While it is held, press a pad from the respective
track to stop Random Perform from affecting it.
RANDOM GENERATOR (destructive) new
Shift + Random activates the Random Generator menu. It allows
you to generate a sequence based on different parameters you can
fine tune to come up with melodic and rhythmic ideas in any
Sequencer mode.
In Multitrack mode Shift + Random toggles between the Euclidean
Generator and the Random Generator. (Euclidean Generator is
explained below).
First set of parameters:
- Bias: step-interval offset around which the new notes are created.
- Rang: range of step-intervals where new notes are created. It’s bipolar, so notes are created
between Bias +/- Range. If Bias is 0 and range is higher than 0, notes will be created above
and below the root note.
- Rand adjusts the amount of variation between generated notes, very low values are good for
arpeggios and high values for less repetitive sequences.
- Dens changes the amount (density) of notes generated. The minimum amount is 1%. Below
1%, there are available the following features:
- Huma: applies humanization to the existing sequence (randomization of velocity, gate
and micro timing offset) according to the Humanization amount, see next options.
- Order: instead of generating a new sequence from scratch, the Randomizer shuffles
the order of notes of the actual sequence, creating variations of it.
- Pitch: instead of generating a new sequence from scratch, Randomizer shuffles the
pitch of the active steps of the current sequence.
Second set of parameters:
To Next Page
Loading...