EasyManua.ls Logo

Panasonic KX-FP342CX

Panasonic KX-FP342CX
247 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
- The document was not fed into the unit properly. Reinsert the
document. If misfeeding occurs frequently, clean the document
feeder rollers and try again. (Refer to DOCUMENT FEEDER ().)
- Attempted to transmit a document longer than 600 mm. Press the
[STOP] to remove the document. Divide the document into two or
more sheets and try again.
- [Alternately, turn off service code #559 to enable sending of
documents longer than 600 mm] (Refer to SERVICE FUNCTION
TABLE ().)
- The memory (telephone numbers, parameters, etc.) has been
erased. Re-program.
[The backup lithium battery on the top of the digital board may be
low or dead, so check it.]
- The recording paper is not installed or the unit has run out of
paper. Install paper and press [SET] to clear the message.
- The recording paper is not fed into the unit properly. Reinstall
paper and press [SET] to clear the message. (Refer to INSTALLING
THE RECORDING PAPER ().)
- The recording paper has jammed near the recording paper
entrance. Clear the jammed paper and press [SET] to clear the
message. Do not install folded or heavily curled paper. (Refer to
RECORDINGPAPER JAMS ().)
- The back cover is open. Close it.
61

Table of Contents

Related product manuals