- The document is jammed. Remove the jammed document. (Refer to
DOCUMENT JAMS - SENDING ().)
- A transmission error occurred. Try again.
- The unit is too hot. Let the unit cool down.
6.2. PROGRAMMING AND LISTS
The programming functions are used to program the various features and functions of the
machine, and to test the machine.
This facilitates communication between the user and the service man while programming the unit.
6.2.1. OPERATION
There are 2 basic categories of programming functions, the User Mode and the Service Mode.
The Service Mode is further broken down into the normal and special programs. The normal
programs are those listed in the Operating Instructions andare available to the user. The special
programs are only those listed here and not displayed to the user. In both the User and Service
Modes, there are Set Functions and Test Functions. The Set Functions are used to program
various features and functions, andthe Test Functions are used to test the various functions. The
Set Functions are accessed by entering their code, changing the appropriate value, then
pressing the SET key. The Test Functions are accessed by entering their code and pressing the
key listedon the menu. While programming, to cancel any entry, press the STOP key.
6.2.2. OPERATION FLOW
64
To Next Page
Loading...
