Panasonic KX-FP342CX

Test Mode Type of
Mode
Code Function
Operation after
code input
MOTOR TEST Service
Mode
“5” “5” “6” Rotates the transmission and reception motor to
check
operation of the motor.
12: Document feed
24: Recording paper is fed
Press [STOP] button to quit.
START
MODEM TEST Service
Mode
“5” “5” “4” Telephone line circuit is connected automatically,
output
the following signals on the circuit line.
1) OFF 2) 9600bps 3)7200bps 4) 4800bps
5) 2400bps 6) 300bps 7) 2100Hz 8)1100Hz
START
ROM CHECK Service
Mode
“5” “5” “1” Indicates the version and checks the sum of the
ROM.
START
SCAN CHECK Service
Mode
“5” “5” “5” Turns on the LEDs of the CIS and operates the
read
systems.
START
LCD CHECK Service
Mode
“5” “5” “8” Checks the LCD indication.
Illuminates all the dots to check if they are normal.
START
DTMF SINGLE
TEST
Service
Mode
“5” “5” “2” Outputs the DTMF as single tones. Used to check
the
frequencies of the individual DTMF tones. Refer
to
SINGLE TONE TRANSMIT SELECTION ().
1....ON
2....OFF
KEY CHECK Service
Mode
“5” “6” “1” Checks the button operation.
Indicates the button code on the LCD while the
button
pressed. Refer to BUTTON CODE TABLE ().
START (any
key)
MEMORY
CLEAR
Service
Mode
“5” “5” “0” To reset the value to the default one, except the
top
(#853), time/day (#001), logo (#002), Fax ID,
History,
Directory.
Please restart a powersupply after clearing a
memory.
START
PRINT TEST
PATTERN
Service
Mode
“8” “5” “2” Prints out the test pattern.
Used mainly at the factory to test the print quality.
You can select 1~4. (See PRINT TEST PATTERN ()
)
START
69