Panasonic KX-NS700 - Call Log, Outgoing

• The Call Log button light shows the current status as follows:
Off: No incoming call, or you have already viewed the call log.
Red on: You have missed calls to view.
• If your call is answered by another extension, the caller’s information is recorded in the logs
of both your extension and the answering extension.
• You can lock your call log display by using an extension PIN (Personal Identification Number),
so that you can prohibit access to your logged information. Refer to "3.1.2 Personal
Programming".
• You can also have a Call Log button for an ICD Group (Incoming Call Distribution Group).
• If a call arrives while you are using the call log, the call log display will be replaced with the
caller’s information.
• Caller information received with a call waiting tone from the telephone company will not be
logged in the call log.
Customizing Your Phone
• 3.1.4 Customizing the Buttons
Create or edit a Call Log button or Call Log for ICD Group button.
1.4.2 Call Log, Outgoing
You can redial using the outgoing call log.
• PS users: Refer to the documentation for your phone.
• KX-UT series SIP phone users: Refer to the documentation for your KX-UT series SIP
phone.
To call
KX-NT300/KX-NT500/KX-DT300/KX-DT500/KX-T7600
Press Left.
Press Up or Down
until desired number
appears.
Off-hook.
While on-hook
• The following PSs can use outgoing call log information to other extensions (including
TIE) with same information as a PT connected to the PBX.
KX-TCA185/KX-TCA285/KX-TCA385
• PSs other than these may not display the same outgoing call log information as a PT
connected to the PBX.
• For details about referencing the outgoing call log, refer to the PS’s documentation.
174 Operating Manual Document Version 2014-11
1.4.2 Call Log, Outgoing