Panasonic KX-NS700 - Call Monitor

• For PT users: The CO or INTERCOM button light shows the current status as follows:
– Regular Hold mode
Flashing green slowly: Your held call
Flashing red: Another extension’s held call
– Exclusive Call Hold mode
Flashing green moderately: Your held call
Red on: Another extension’s held call
• For KX-UT133/KX-UT136/KX-UT248/KX-UT670 SIP phone users: The S-CO button light
shows the current status as follows:
– Regular Hold mode
Flashing green slowly: Your held call
Flashing red: Another extension’s held call
• If a call is not retrieved within a specified time, you will hear an alarm as a reminder (Hold
Recall).
If an outside call is not answered within a specified time, it is automatically disconnected.
• Hold Mode Change (PT only)
After pressing the HOLD button, if you press the HOLD button again, the status switches
from the Regular Hold mode to the Exclusive Call Hold mode or from the Exclusive Call Hold
mode to the Regular Hold mode.
• If Automatic Call Hold has been preprogrammed, you can put the current call on hold
automatically by pressing another CO, ICD Group, INTERCOM, or DN button to make or
answer another call.
• For the Call Hold Retrieve operation using a PDN/SDN button, refer to "1.3.51 PDN (Primary
Directory Number)/SDN (Secondary Directory Number) Extension".
1.3.7 Call Monitor
A preprogrammed extension user can listen to the ongoing conversation of a busy extension user.
After pressing a DSS button, you can check the caller information of the call to another extension on the display.
Then, you can choose to monitor the call, if necessary.
To monitor
PT/SLT/PS
Enter 5.
5
Off-hook.
C.Tone
Monitoring starts
B. Tone
Press red DSS, PDN, or SDN, or dial extension number.
extension no.
(SDN)
OR
OR
(PDN)
OR
(DSS)
A busy tone is heard and the caller
information of the call to another
extension is displayed.
• SIP phone users cannot use this feature, but they can be monitored by other extensions.
44 Operating Manual Document Version 2014-11
1.3.7 Call Monitor