Panasonic KX-TDA100D

Number in
the Pattern
Item Description
(5) Dial Number [Trunk Call]
Outgoing Trunk Call
Shows the dialled telephone number.
Valid digits are as follows:
0 through 9, , #
P: Pause
F: EFA signal
=: A Host PBX Access code (® 1.5.4.8 Host PBX Access Code
(Access Code to the Telephone Company from a Host PBX))
. (dot): Secret dialling
X: Privacy dial
–: Transferred call
If the transfer destination extension enters some digits, the
entered digits will be added after "–".
Incoming Trunk Call
Shows <I> + the caller’s identification name/number.
It is also possible to show the DDI/DID/MSN call information. In
this case, <D> + DDI/DID/MSN name/number is added before
<I>.
[Outgoing Intercom Call]
Shows the dialled extension number followed by "EXT".
[Log-in/Log-out]
Shows the log-in or log-out status.
[Check-in/Check-out]
Shows the check-in or check-out status. (® 1.27.2 Room Status
Control)
[Timed Reminder]
Shows the status of a timed reminder, either "Start", "No
Answer", or "Answer". (® 1.28.4 Timed Reminder)
[Printing Message]
Shows the selected message. (® 1.26.2 Printing Message)
[Sensor Call]
Shows calls from an external sensor as follows:
<I> S + sensor number. (® 1.17.9 External Sensor)
(6) Ring Shows the ring duration before answering a call in Minutes/
Seconds.
(7) Duration Shows the duration of the trunk call in Hours/Minutes/Seconds.
(8) Acc Code
(Account
Code)
Shows the account code appended to the call. (®
1.5.4.3 Account Code Entry)
286 Feature Guide
1.26.1 Station Message Detail Recording (SMDR)