2.5.4.9 Intercom Paging Parameters
VPS Intercom Paging functions in conjunction with the Intercom Paging feature of the PBX. It allows the VPS
to page the called party (announce the caller’s name, line number, etc.) while the caller is placed on hold. To
utilize this feature, Intercom Paging must be available for the PBX, and the VPS must be properly programmed.
This feature is available for APT/DPT Integration only.
Intercom Paging Sequence
Specifies the intercom paging sequence used to activate the Intercom Paging feature of the PBX. The settings
made here must match the settings of the PBX. The sequence can be a combination of 7 letters and 12 dial
codes.
Default
FX,
Value Range
Max. 16 digits consisting of 0–9,
, # and special codes
D: Disconnecting
F: Flash (Recall)
R: Ringback Tone Detection
T: Dial Tone Detection
,: Dial Pause for 1 s (default)
;: Dial Pause for 3 s (default)
X: Pager Dialing
0–9, , #: Dial Codes
Document Version 3.0 2010/06 Programming Manual 169
2.5.4 Parameters
To Next Page
Loading...
