1.3 Starting KX-TVA Maintenance Console
The instructions listed below explain how to start KX-TVA Maintenance Console. These instructions are for
when connecting to the VPS via USB.
Note
• The screenshots shown here are for reference only, and may differ from the screens displayed on your
PC.
1. Click the KX-TVA Maintenance Console shortcut icon.
2. Select the appropriate VPS model and click OK.
3. The Enter Programmer Code dialog box is displayed. Enter the installer level programmer code (default:
INSTALLER) and click OK.
Note
• A programmer code is required to use the KX-TVA Maintenance Console. The System
Administrator can change the programmer codes (see 1.9.9 Utility—Programmer Code).
4. The Set Default Parameters window is displayed the first time you start KX-TVA Maintenance Console.
Select the TVA Type, PBX Type, and Integration Mode. Change the default parameters listed in the window
if necessary, then click OK.
Document Version 3.0 2010/06 Programming Manual 11
1.3 Starting KX-TVA Maintenance Console
To Next Page
Loading...
