Disconnect Time
Specifies the length of time the line will be unavailable after a call has ended.
Default
2 s
Value Range
1 s–8 s
Delay After Dialing Before Analysis
Specifies the length of time between the end of call and the start of Call Progress Tone detection when an
outgoing call is dialed.
Default
0 ms
Value Range
0 ms–20000 ms, units 100 ms
Maximum Time to Wait for Dial Tone
Specifies the length of time that the VPS waits for dial tone detection.
Default
5000 ms
Value Range
500 ms–20000 ms, units 100 ms
Dial Start Mode
Specifies whether dialing starts after a dial tone is detected or after the time specified in "Offhook Delay" has
passed.
Default
Delay Mode
Value Range
Dial Tone Mode, Delay Mode
Offhook Delay
Specifies the length of time that passes before dialing starts. This setting is only needed when "Dial Start
Mode" is set to "Delay Mode".
Default
3000 ms
Value Range
500 ms–20000 ms, units 100 ms
190 Programming Manual Document Version 3.0 2010/06
2.6 Hardware (H/W) Settings
To Next Page
Loading...
Need help?
General
