11. Using the Wi-Fi/Bluetooth function
234
When [Wi-Fi Password] is set to [ON], you can enhance security by using manual entry or
a QR code for password authentication.
Preparations: (On the camera) Set [Wi-Fi Password] to [ON]. (P269)
∫ Using the QR code to set up a connection
(On the camera)
A SSID and password
B QR code
• The information (QR Code, SSID and Password) required for
directly connecting your smartphone to this unit is displayed.
• You can also display the information by pressing [Wi-Fi] on the
camera.
(On your smartphone)
1 Start “Image App ”.
2 Select [QR code].
• When the smartphone is connected to a wireless access point, it may take time to display
[QR code].
• (For iOS devices) A confirmation screen will be displayed. Select [OK] to proceed.
3 Use the “Image App” to scan the QR code displayed on the screen of the camera.
• To enlarge the QR code, press [MENU/SET] on the camera.
4 Install the profile.
• If a pass code is set on the smartphone, you need to enter it.
5 Press the home button to close the browser.
6 Turn on the Wi-Fi function in the smartphone’s setting menu.
7 On the Wi-Fi setting screen, select the SSID displayed on the
camera.
8 Start “Image App ”.
• (iOS devices) Steps 1 through 5 are not required from the second
time on.
Using a password to set up a connection
> [Setup] > [Wi-Fi] > [Wi-Fi Function] >
[New Connection] > [Remote Shooting &
View]
If you are using an Android device, follow the steps up to here to complete the setup.
Proceed to the steps below only if you are using an iOS device (iPhone/iPod touch/iPad).
MENU
To Next Page
Loading...
