4. Focus, Brightness (Exposure) and Colour tone Settings
92
• In Manual Exposure Mode, you can compensate the exposure only when the ISO sensitivity is
set to [AUTO].
• Depending on the brightness, this may not be possible in some cases.
• When [Auto Exposure Comp.] in [Flash] in the [Rec] menu is set to [ON], the brightness of the
flash will automatically be set to the level appropriate to the selected Exposure Compensation.
(This applies if the exposure is set with a function button)
• If you assign [Exposure Comp.] to a function button, the exposure compensation dial will be
disabled.
• You can set a value between
j3 EV and i3 EV while recording motion picture or performing
recording with the 4K Photo or Post Focus function.
• When the Exposure Compensation value is out of the j3EV to i3 EV range, the brightness
of the recording screen will no longer change. It is recommended to record by checking the
actual brightness of the recorded image in the Auto Review or playback screen.
• The exposure compensation value set with the function button is stored even if you set the
camera on/off switch to [OFF]. (When [Exposure Comp. Reset] is set to [OFF])
To Next Page
Loading...
Need help?
General
