253
SQW0038
Wi-Fi
Using WEB services
[Send Images While Recording]
1
Set the menu
→ [New Connection] → [Send Images While Recording] → [Web service]
2
Select [Via Network] and connect (→264)
3
Select a WEB service you want to connect
• When the connection is established, the confirmation screen for the transmission setting is
displayed. Check the setting and press [MENU/SET]. To change the send setting, press [DISP.]
button. (→271)
4
Take still pictures
• To change the setting or disconnect, press [Wi-Fi] button. (→226)
You cannot change the settings while sending still pictures. Wait until sending is complete.
(You can also close the connection by pressing
→ [Setup] → [Wi-Fi] →
[Wi-Fi Function] → [Yes].)
[Send Images Stored in the Camera]
1
Set the menu
→ [New Connection] → [Send Images Stored in the Camera]
→ [Web service]
2
Select [Via Network] and connect (→264)
3
Select a WEB service you want to connect
• When the connection is established, the confirmation screen for the transmission setting is
displayed. Check the setting and press [MENU/SET]. To change the send setting, press [DISP.]
button. (→271)
4
Select [Single Select] or [Multi Select]
[Single Select]
Select the picture
Press [MENU/SET]
[Multi Select]
Select the picture (repeat)
• If selected again, the setting will be cancelled.
Select [OK]
• The number of pictures that can be sent by [Multi Select] is
limited.
2 3
4 5 6
1
OK
• A confirmation screen is displayed. If you select [Yes], the operation is executed.
• To change the send setting, press [DISP.] button.
• To close the connection, select [Exit].
To Next Page
Loading...
