315
SQW0038
Others
Q&A Troubleshooting
■
Flash
Unable to perform [Flash].
• Flash (supplied/optional) is not attached properly.
→ Properly attach a flash (supplied/optional) to the camera. (→176, 291)
• For details about flash settings, refer to (→176 - 186, 291).
No flash emitted.
The flash becomes unavailable in the following cases.
• When the picture effect (Filter) is set
• When camera is set to use [Auto Bracket], White Balance Bracket, or [Aspect Bracket]
• When using [Burst]
• During panorama picture recording
• When [HDR] is set to [ON]
• When the electronic shutter is used (→140)
→ Set [Shutter Type] to [AUTO] or [MSHTR].
• When [Silent Mode] is set to [ON] (→161)
→ Set [Silent Mode] to [OFF].
The flash fires twice.
• The flash (supplied) fires twice. (Except when [Firing Mode] of [Flash] is set to [MANUAL]) When
red-eye reduction (→180) is set, the firing interval will be longer. Make sure that the subject does
not move until the second firing is completed.
To Next Page
Loading...
