No. SX-DSV02472 -118-
*1) Select the warning output signal 1 (WARN 1) or warning output signal 2 (WARN 2) through Pr 4.40 “Warning output
select 1” or Pr 4.41 “Warning output select 2”. When the set value is 0, all warnings are ORed before being output. Do
not set to any value other than those specified in the table above.
*2) A waning detection can be disabled through Pr 6.38 Warning mask setting, by setting the bit shown below to 1.
For extended warning, warning detection can be disabled by parameter settings.
Also note that bit arrangements of these masks are different from those of general purpose type MINAS-A5 series.
*3) Effective only with 20-bit incremental encoder.
*4) Warning can be cleared by alarm clear. If warning cause is not resolved yet, once cleared warning is issued again.
R1.05
Motor Business Division, Appliances Company, Panasonic Corporation
To Next Page
Loading...
