Chapter 4 Settings — [SECURITY] menu
132 - ENGLISH
2) Press the <ENTER> button.
f The [CONTROL DEVICE SETUP] screen is displayed.
3) Press as to select [CONTROL PANEL] or [REMOTE CONTROL].
4) Press the <ENTER> button.
5) Press as to select [CONTROL PANEL] or [REMOTE CONTROL].
6) Press qw to switch [USER].
7) Press as to select the button item to set.
f When [INPUT SELECT BUTTON] is selected, press the <ENTER> button, and then press as to select the button to set.
Buttons that can be set
[CONTROL PANEL] [REMOTE CONTROL]
[POWER BUTTON]
Power standby <v> button, power on <b> button
[INPUT SELECT BUTTON]
<VIDEO> button, <RGB1/RGB2> button, or <RGB1/2> button, <DVI-D> button, <HDMI> button,
<DIGITAL LINK> button, and <SDI> button
*1
[MENU BUTTON] <MENU> button
[LENS BUTTON] <LENS> button Lens (<FOCUS>, <ZOOM>, <SHIFT>) button
[AUTO SETUP BUTTON] <AUTO SETUP> button
[SHUTTER BUTTON] <SHUTTER> button
[ON SCREEN BUTTON] — <ON SCREEN> button
[OTHER BUTTON]
asqw, <ENTER> button
Buttons not listed above
*1 Only for PT-DZ870E
8) Press qw to switch the item.
[ENABLE] Enables button operations.
[DISABLE] Disables button operations.
f The following items are available only when [RGB1/2 BUTTON] of [INPUT SELECT BUTTON] is selected.
[TOGGLE] Switches between RGB1 and RGB2 when the button is operated.
[RGB1] Fixes to RGB1.
[RGB2] Fixes to RGB2.
[DISABLE] Disables button operations.
f When [INPUT SELECT BUTTON] is selected in Step 7), and after the item is switched, press the <MENU> button to return to the
[CONTROL PANEL] screen or the [REMOTE CONTROL] screen.
9) Press as to select [APPLY], and press the <ENTER> button.
f The conrmation screen is displayed.
10) Press qw to select [OK], and press the <ENTER> button.
Note
f When a button operation is performed on the device set to [DISABLE], the [CONTROL DEVICE PASSWORD] screen is displayed.
Enter the control device password.
f The [CONTROL DEVICE PASSWORD] screen will disappear when there is no operation for approx. 10 seconds.
f If the operations of both [CONTROL PANEL] and [REMOTE CONTROL] are set to [DISABLE], the projector cannot be turned off (cannot
enter standby).
f When the setting has completed, the menu screen will disappear. To operate continuously, press the <MENU> button to display the main
menu.
f Even when button operation on the remote control is disabled, operation of the <ID SET> button on the remote control is enabled.
To Next Page
Loading...
