Panasonic PT-DZ870E

Chapter 1 Preparation — Start-up display
ENGLISH - 23
Initial setting (installation setting)
Set [PROJECTION METHOD] and [COOLING CONDITION] depending on the installation mode. Refer to “Installation mode” (x page 32)
for details.
Set [HIGH ALTITUDE MODE] to [ON] when using the projector at high altitudes between 1 400 m (4 593') or higher and lower than 2 700 m
(8 858') above sea level.
After completed the initial setting, you can change the settings of each item from the [PROJECTOR SETUP] menu.
1) Press as to select an item.
2) Press qw to switch the setting.
2/4
When PROJECTION METHOD is changed, confirm that
COOLING CONDITION is set correctly.
It may shorten the life of the lamp and projector if used
in incorrect setting.
Switch to HIGH ALTITUDE MODE "ON" if over 1400m
(4593Ft).
INITIAL SETTING
SET
CHANGEMENU SELECT
PROJECTION METHOD
COOLING CONDITION
FRONT/FLOOR
AUTO
HIGH ALTITUDE MODE
OFF
ENTER
3) Press the <ENTER> button to proceed to the initial setting.
Initial setting (stand by mode)
Set the operation mode during the standby. The default setting is [ECO] that keeps power consumption low during standby. When the network
function is used during standby, set to [NORMAL]. After completed the initial setting, you can change the settings of each item from the
[PROJECTOR SETUP] menu → [STANDBY MODE].
1) Press as to select an item.
2) Press qw to switch the setting.
3/4
When set to ECO, network functions and SERIAL OUT
terminal, and some RS-232C commands are not
available during standby.
INITIAL SETTING
SET
CHANGE
STANDBY MODE
ECO
ENTER
3) Press the <ENTER> button to proceed to the initial setting.