Chapter 1 Preparation — Start-up display
24 - ENGLISH
Initial setting (screen setting)
Set the screen format (aspect ratio) and display position of the image. After completed the initial setting, you can change the settings of each
item from the [DISPLAY OPTION] menu → [SCREEN SETTING].
1) Press as to select an item.
2) Press qw to switch the setting.
16:10
4/4
SCREEN POSITION
Set as necessary for the screen in use.
INITIAL SETTING
SET
CHANGEMENU SELECT
SCREEN FORMAT
ENTER
3) Press the <ENTER> button.
f Conrm the setting value and complete the initial setting.
Note
f If you press the <MENU> button on the initial setting screen, you can go back to the previous screen.
f To continue operations after completed the initial settings, refer to “Selecting the input signal” (x page 58).
f By default, the time zone of the projector is set to +09:00 (Japan and Korean Standard Time). Change the setting in the [PROJECTOR
SETUP] menu → [DATE AND TIME] → [TIME ZONE] to the time zone of the region where you use the projector.
To Next Page
Loading...
