Chapter 4 Settings — [NETWORK] menu
142 - ENGLISH
Parameter Description
[AIR FILTER]
There is too much dust accumulated in the air lter. Turn the <MAIN POWER> switch
<OFF> (x page 57), and clean the air lter. (x page 160)
r [WARNING] items
Parameter Description
[AC POWER]
AC input voltage is weak. Use electric wiring that can sufciently withstand the power
consumption of the projector.
[LOW-TEMPERATURE]
The temperature around the optics module inside the projector is low. Projection cannot
be started until the optics module becomes warm.
[HORIZONTAL TILT]
The projector is used tilting at an angle that exceeds 15° from the horizontal plane.
When using the Replacement lamp unit (for portrait mode), install the projector with the
terminals surface facing down.
[LIGHT OUTPUT LIMIT]
The projector may be used in an environment where the temperature is high. The light
output is reduced by approx. 20 % to protect the projector.
[LAMP MIX] The Replacement lamp unit (for portrait mode) and normal lamp unit are mixed.
[Network status] page
Click [Status] → [Network status].
The current network setting status is displayed.
[Access error log] page
Click [Status] → [Access error log].
The error log on the web server is displayed such as access to the pages that do not exist or access with unauthorized user names or
passwords.
To Next Page
Loading...
