INF-17
SECTION 1 SERVICE INFORMATION
<RZ31K/RS30K>
4. POWER OFF MESSAGE
• Setting of the shutter function with standby operation
- SHUTTER KEEP: When pushing the standby key while the shutter mode is on, the projector keeps the shutter mode on
and sets into standby mode.
- SHUTTER OPEN: When pushing the standby key while the shutter mode is on, the projector opens the shutter and displays
the "Power OFF confirmation message". (Default setting)
5. ERROR OSD
• Enables to display the error information of the LIGHT indicators on the screen (It is useful when using the projector with
rear projection mode)
- ON : "LIGHT1\LIGHT2 ERROR" is displayed on the screen if the lighting error occurs. (It will disappear when any of the
control buttons is pressed.)
- OFF : No message is displayed on the screen if the lighting error occurs. (Default setting)
6. ELECTRIC CONVERGENCE
• Aligns the convergence electrically. Refer to chapter SECTION 3 (Adjustments)
7. MECHANICAL CONVERGENCE
• Aligns the convergence mechanically. Refer to chapter SECTION 3 (Adjustments)
8. MODEL
This setting is necessary when the A-P.C. Board is replaced with new one.
• If you can copy EEPROM data from old A-P.C. Board, this setting is unnecessary.
• This model setting is effective after power restart.
9. CLOG SENSOR CALIBRATION
• This is to calibrate the clog sensor circuit. This calibration is necessary when the [A]-P.C Board, EEPROM (IC3711/IC3712)
or [M2]- P.C. Board is replaced.
• Refer to the chapter SECTION 3 (Adjustments) for the procedure.
10. LIGHT ADJUST
• Used to take a optical adjustment.
– LIGHT SELECT
Select the LD to turn on. Press the [ENTER] key to switch.
– ALL : Both of LD1/LD2 turn on (Default)
– LD1 : LD1 turns on
– LD2 : LD2 turns on
*The selection will be reset to "ALL" after turning off the projector.
– LIGHT ADJUSTMENT MODE
Select a lighting pattern when taking optical adjustment.
– TEST PATTERN
Select a test pattern (white raster) when taking optical adjustment.
Pump 6 (PUMP2B)
Pump 4 (PUMP1B)
Pump 5 (PUMP1S)
Pump 7 (PUMP2S)
Pump 1 (PUMP-R)
Pump 2 (PUMP-G)
Pump 3 (BUMP-B)
l Cooling pumps location
To Next Page
Loading...
